When I try to run recovery, it runs for a little and then goes to a "no" symbol, with the spinner still spinning. I am concerned that the HD may be dead/dying, but I don't want to jump to that conclusion yet.How do I either boot to my USB, or just get a restore done?I have already successfully backed up my files. I just want to restore the machine.I made the USB Boot drive from this guide:Specifically choice number 1, where I downloaded the OS from the App Store and ran the terminal commands on a pre-formatted USB drive.Below you will see the Disk Utility for the USB drive. Not sure how to tell if it is a Boot disk or not.The below screenshot shows EFI in Debug mode in Disk Utility.For what it's worth, when I plug in this drive into my working MBP, I see the "Install OS X Yosemite" get mounted in Finder.Here is a screenshot of the "Startup Disk" option within "System Preferences" on my working MBP that has the Bootable USB plugged in - which proves that it was properly created, I believe. You can check the screenshot to confirm though.Output from bless -info.
![]() ![]() What If The Bootable Command Usb Drive Is Not Found Windows 10 ISO IsIdentify the USB DriveRun diskutil list in Termainal and a list attached disk drives will beDisplayed. I think you can figure this one out, but if you’re using a new Macbook ProLike me you probably need a USB-C to USB-A adapter, and that sucks. If you’re lucky enough to have gigabit internet, then I guess youCan just wait the 50-ish seconds it’ll take? Plug the USB Drive into your MacOK. Get Tea or Coffee ☕Since the Windows 10 ISO is ~5.5GB, maybe now is a good time to have a drink?It’ll take a few minutes to download, even on a reasonably fast internetConnection. You can do so at this link on microsoft.com. Microsoft package for students mac nc stateYou don’t need to paste them since they do nothing. That means it deletes everything on the drive, so you want to be sure it’s the right one! Format the USB DriveFormat the drive using the following commands:Note: The lines beginning with # are comments explaining what the command on the line below does. The next step involves formatting the drive. We’llStore that in a variable for use later by running the commandI used /dev/disk2 in the example DRIVE_MOUNT, but make sure you change it to the correct path for your USB drive.
0 Comments
Leave a Reply. |
AuthorAshok ArchivesCategories |